GitHub - notaroomba/keybytes: A truly modular keyboard
A truly modular keyboard. Contribute to notaroomba/keybytes development by creating an account on GitHub.
A truly modular keyboard. Contribute to notaroomba/keybytes development by creating an account on GitHub.
Key Features • Video Demo • Connecting Keybits • PCB • Credits • License
Typing over USB:
demo2.mp4V1 had a CH32V003 on every key with pogo pins on all 4 sides and an STM32WB55 Keyword split into two stacked PCBs. It lives in the v1 branch.
The side contacts are the magnets themselves. Every side has 6 contact magnets on a 2.38mm grid with the A and B nets alternating, so two keybits connect no matter which way round they are and at any 0/25/50/75% stagger. Each side has a small FET bridge that connects whichever net is higher to VBUS and the other one to GND, so polarity doesn't matter either.
Flashing keybits: the 4 pogo pins on top of the keyword (GND, TIO, TCK, 3V3) line up with the pads on the bottom of every keybit, so a keybit gets flashed by pressing it onto the keyword. After that it updates over OTA.
The v2 firmware for the CH592F is still in progress. The v1 status LED codes are in the v1 branch.
Designed in KiCad! There are two main boards, the Keybit and the Keyword, plus passive flex spacers (1u, 0.75u and 0.5u) that pass power across gaps.
A single key on a cross shaped 2 layer flex PCB with a CH592F in the middle, a WS2812 RGB LED and Mill-Max 3305 hot swap sockets for the switch. The 4 flaps fold up into the case and have FR4 stiffeners, and each one has 6 contact magnets and a FET bridge for power. The pads on the bottom are for flashing it from the keyword. The hall variant has a TMAG3001 3-axis hall sensor, so the same board can be a hall key, a knob (in the encoder case) or a joystick.
Schematic:
Layout:
3D View:
The main board that the keybits connect to. It is now one flex board with a CH592F for BLE and USB-C, a BQ25185 charger for a small LiPo and a USBLC6 for ESD protection. The 4 SMD pogo pins on the top (GND, TIO, TCK, 3V3) are for flashing the keybits.
Schematic:
Layout:
3D View:
Everything is panelized for JLC flex PCBA. The files are in production/panels: 8x3-panel is the full order, 2x3-test-panel is a smaller test order and spacer-panel is the bare flex spacers.
This project uses:
MIT
Texto de github.com tal como lo publicó, leído de su página y mostrado aquí con el formato de El Autómata. El original, en github.com · Volver a la noticia de El Autómata